Fall from collapsing structure or equipment less than 6 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Glanbia Foods, Inc., 1045 Agri Lane, GOODING, IDAHO 83330
on — Fractures, affecting the thigh(s).
Final narrative
An employee opened a rolling door, then walked out on a dock plate to speak to the driver of a delivery truck that was being unloaded. The dock plate collapsed, causing the employee to fall approximately 4 feet. He broke a femur and injured his hip, requiring hospitalization.
HospitalizedThigh(s)Ramps, loading docks, dock plates
An employee was working at the calcium flow board when the gasket from the outflowing hydrogen sulfide tank failed. The resultant pressure pushed the sodium hydroxide solution 15 feet to where the employee was working. The chemical caused burns to 12% of the backside of the employee's lower legs.
While troubleshooting a conveyor system, an employee's right hand became caught in the machinery. The employee sustained some degloving and two fingertips were amputated.
Two maintenance workers were servicing an electronic fill button on a nearby 12 to 17 percent sodium hypochlorite chemical day tank. A 1-inch chemical line became dislodged and sprayed both employees, causing chemical burns on their chests, torsos, and arms. Both employees were hospitalized.
An employee was using a two-step step stool to stock product on shelves. The stool collapsed and the employee fell to the ground sustaining a fractured femur.
An employee was walking around and closing up the office for the day. As he was on a table closing the blinds, the table collapsed, causing the employee to fall. He sustained a left kneecap fracture.
Employees were demobilizing a microtunneling operation from inside of a 42-foot shaft. They were standing on a 3-foot high pump stand to disconnect the pump when the pump dropped, and the stand gave way. This caused the employees to slide and fall to the ground. The injured employee fell on his left side, landing on an oil can with his co-worker landing on top of him. The injured employee was hospitalized for a rib fracture.
An employee was on a wood platform surrounding a containment wall to work on a transformer. While inspecting the equipment, the wood platform collapsed, causing the employee to fall approximately 4 feet. The employee's shoulder was fractured and required surgery.
An employee was standing on a baker's scaffold approximately 3 feet above finished floor to install equipment. While taking measurements, the locking pins came out on one end of the scaffold, causing the scaffold to collapse. The employee fell 3 feet and sustained a left ankle injury.
More severe injuries in this industry (NAICS 424430)
An employee was lifting a crate of dairy product and felt severe back pain. The employee was hospitalized with a burst blood vessel in their lower back.
An employee was walking between two production lines when he tripped and fell over a pallet that had some equipment on it. The employee fell on his right side, resulting in a fractured hip and a possible thumb injury.
An employee was using a stand-up forklift to load a small box truck. As he was putting down a pallet to push it onto a truck, the weight caused the truck to move forward. This pulled the forklift forward and it dropped between the truck and the loading dock, causing partial amputations to their left little and ring fingers.
An employee was unloading product from a trailer onto a scissor lift. They stepped backward and fell approximately 5 feet from the scissor lift to the concrete floor, sustaining six broken ribs and a punctured lung.
An employee was removing cheese product from the top of a conveyor belt. His right ring finger got pulled under the metal product guide rail at the edge of the conveyor and was pinched between the conveyor and the guide rail. The employee sustained an amputation of the fingertip between the first knuckle and the fingernail.
An employee was diagnosing the lack of flow of product to a powder bin. The employee removed the rotary star valve below the bin. While he was reinstalling the valve, his right middle finger was crushed between its shaft and its housing. The finger was partially amputated.
An employee was standing on a multi-purpose ladder installing head flashing over a window. Their feet were approximately 6 feet off the ground and three rungs from the top. The employee lost their grip on the drill they were using and the ladder tipped over. The employee fell from the ladder to the ground, resulting in a fractured left wrist, bruised chest, and lacerations to their face and lip.
An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.
An employee was loading a 4-inch wooden door into a pickup truck when he felt a pop in his right side behind his shoulder blade. He was hospitalized later that day and underwent surgery, having suffered a collapsed right lung.