Textron Ground Support Equipment, Inc.

An employee was using a pneumatic jack to lift a tractor. The employee placed the jack under the tractor and began to raise the vehicle when the jack came out from under the vehicle and struck the employee's lower left leg, resulting in a severe laceration.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

Two employees fell from an access bridge while entering an aircraft to perform maintenance. They landed on the ground about 20 feet below, where one of them lost consciousness. One employee sustained a fractured knee and another employee sustained a back strain/sprain. Both employees were hospitalized.

An employee experienced sharp pain in his lower torso area while loading baggage into the front cargo pit of an aircraft. The employee sustained a hernia.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

On September 11, 2025, an employee was lowering a railing system on an aircraft fueling cart when his gloved right ring finger was caught in the folding railing system, resulting in a fingertip amputation that required hospitalization and surgical reattachment.

An employee was working at ground level when an aviation engine cylinder weighing 30 pounds fell from a seven-foot high shelf and struck the employee on the head. The employee suffered a fractured skull and was hospitalized.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.