United Airlines

An employee was offloading a new boom lift from a transporter truck. As the boom lift s rear wheels reached the tail lift of the truck, the tail lift broke, causing the boom lift to fall. As a result of the sudden drop, the employee was lifted into the air, striking several objects. The employee was hospitalized due to a fractured back and a left leg injury that required stitches.

An employee turned off a pushback tractor at a gate, put it in neutral, and put the emergency brakes up. The employee then exited the tractor and noticed it was rolling forward toward the aircraft. The right side of his body was wedged between the tractor and the aircraft nose. The employee was hospitalized for fractured ribs and a partially collapsed lung.

An employee was reversing a tug into a baggage cart to connect it when the tug did not stop and struck them in the lower trunk area. The employee was hospitalized.

An employee was operating a tug and going around a parked cart when the tug struck the cart, catching their left foot between them. The employee was hospitalized with fractures to their left tibia and fibula.

An employee was positioning a tug tractor next to its charging station when her left foot was caught between the tug and a pillar, resulting in a foot fracture.

An employee sustained a hernia while carrying a 25-pound gas cylinder. The employee was hospitalized and required surgery.

An employee was loading a 4-inch wooden door into a pickup truck when he felt a pop in his right side behind his shoulder blade. He was hospitalized later that day and underwent surgery, having suffered a collapsed right lung.

An employee was lifting a crate of dairy product and felt severe back pain. The employee was hospitalized with a burst blood vessel in their lower back.

An employee was lifting a box of produce in the backroom area when she suffered pain in her lower back and was unable to stand, resulting in hospitalization.

An employee was operating a machine. When they performed a motion to push a machined engine block away from their body, they experienced a back strain, resulting in hospitalization.

Two employees fell from an access bridge while entering an aircraft to perform maintenance. They landed on the ground about 20 feet below, where one of them lost consciousness. One employee sustained a fractured knee and another employee sustained a back strain/sprain. Both employees were hospitalized.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

On September 11, 2025, an employee was lowering a railing system on an aircraft fueling cart when his gloved right ring finger was caught in the folding railing system, resulting in a fingertip amputation that required hospitalization and surgical reattachment.

An employee was working at ground level when an aviation engine cylinder weighing 30 pounds fell from a seven-foot high shelf and struck the employee on the head. The employee suffered a fractured skull and was hospitalized.

An employee was squatting to lift a 20-pound aircraft panel when they suffered a pulled muscle in their left hamstring and gluteus.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.