Goodman Manufacturing Company, L.P.

An employee was working at a die transfer system when their finger became caught between the crossbar and the edge of the die in the transfer system. The employee sustained a finger amputation.

An employee sustained a cut on their leg.

The injured employee was parked in a tugger. A reach truck driver was relocating a container that was behind a stack of containers. The forks came into contact with the stack of containers, tipping it over onto the injured employee's tugger. The injured employee was hospitalized with lacerations to both hands and the right side of their face.

An employee was removing material from a container when the material shifted, causing his right pinky fingertip to be caught between the material and the wall of the container. The employee sustained a partial amputation to the right pinky fingertip.

An employee was putting a bend channel in a sheet of metal using a press brake. The brake actuated and the sheet metal rose up against the brake die, smashing the employee's fingers between the brake die and the sheet metal. The employee suffered a partial amputation of the left middle finger at the last joint.

An employee was riding on a powered pallet jack near a sewer drain. The pallet jack hit a dip near the sewer drain, and the employee s left foot hit a clamp truck parked in a charging station. He suffered a cut to the big toe, as well as fractures in the toe and the foot.

An employee went to step off material handling equipment to grab their jacket when the throttle of the vehicle engaged. The vehicle reversed and the employee's left foot was crushed between two material handlers, resulting in a fracture.

An employee was working at a height of approximately 20 feet and was standing outside his forklift's basket attachment. His forklift was struck by another forklift, causing the employee to fall to the warehouse floor below. The employee sustained facial injuries, broke two ribs and an arm, and also suffered a head injury. The employee was wearing a harness at the time but it was not connected to an anchor point.

On November 8, 2023, an employee was operating a stand-up pallet jack in the warehouse. As he was backing up, the pallet jack struck the basket of a parked aerial lift. His right ankle became caught between the pallet jack and the aerial lift basket resulting in a fractured ankle.

On October 26, 2023, at approximately 12:00 PM, an employee operating a four wheeler was on their way to an off-property break location. The employee stopped the four wheeler near the administrative office to allow a log truck to exit the property. The log truck backed up, and the employee's left ankle was caught between the log truck trailer and the four wheeler, resulting in a fracture and laceration.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was holding a piece of rubber while it was being cut on a band saw. The saw blade amputated his right middle fingertip without bone loss.

An employee was observing expansion rods on a coil expander going into a coil to ensure copper stubs weren't being bent. His left hand was caught between the locking block and locking block clamp on the power press machine, resulting in partial amputation of his left little finger from the distal interphalangeal joint.

An employee was setting up a press brake and rolling over a die when the tip of their left little finger was caught between the horizontal working surface of the press brake and die. The employee sustained partial amputation of their fingertip.

An employee was working to remove an access panel to begin performing maintenance on a machine. The set pins on the bottom of the panel were broken. The bottom kicked out and fell, striking the employee's left foot and resulting in a fracture to the big toe.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.