Key Energy Services

An employee was hospitalized for heat illness.

An employee was assisting with rigging up a derrick. He was at the back end of the rig when he grabbed a bar with his right hand. As the rig was going up, his right hand went under the tail screw, which crushed his little finger, resulting in amputation.

Employees had been nippling up the blow out preventer (BOP) system. The work floor of the rig unfolded and descended on top of an employee resulting in contusions to multiple body parts.

An employee was setting a 90-degree elbow while another employee operated the crown. The block dropped and crushed the employee's right hand.

An employee's gloved finger was caught while aligning a swivel causing a fingertip amputation.

An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.

An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.

An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.

An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.

An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.

An employee was slipping pipe when it became stuck and the pipe snapped, striking the employee in the back and ribs. The employee sustained fractured ribs.

An employee was checking voltage and fuses to see where power loss was occurring. He touched a magnetic coil and was shocked.

An employee was standing on an injector head feeding chain with a rope, when the rope broke, causing him to lose his balance and fall to the ground. The employee sustained fractures to his left elbow and three ribs.

An employee was pulling drill line from the drill spool while the top drive was not set on the docking pins. The deadman was unexpectedly released which caused the top drive to fall to the drill floor from a height of 30 feet. This caused the drill line that was being pulled out and laid on the ground to retract and strike an employee. The employee suffered fractures to his legs and neck.

An employee was conducting maintenance on a pipe and was using a T-bar tool to secure the retainer cap on a pump. The employee's left index finger was caught in the rotating pump, resulting in a partial amputation.

An employee fell from a dock to ground level (less than 4 feet) and broke their tibia/knee.

An employee was on the ground working to close a trailer door. The door was caught by the wind and blew the employee backward. He landed on his back and sustained four fractured ribs, requiring hospitalization.

An employee was walking on top of boiler to close a valve. The employee fell off the boiler and landed on the floor, sustaining fractured ribs. The employee was hospitalized.

An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.

An employee's left bicep was lacerated by high-pressure water during water blasting operations. The employee was hospitalized.