Xtreme Drilling & Coil Services, Inc.

On December 30, 2023, an employee was pulling a pallet into the back room when a forklift rounded the corner and ran over the employee's right foot. Three of the employee's toes were amputated.

An employee was unwrapping a pallet of empty buckets. The employee stepped backward and was struck by a powered industrial truck carrying a pallet of bucket lids, resulting in a left ankle fracture.

An employee was walking in the racking area to check parts when they were struck by an oncoming forklift. The front wheel ran over the employee's right leg, resulting in fractures to the leg and ankle.

An employee was exiting a trailer for it to be loaded when their right ankle was pinned between a piece of angle iron that was anchored to the floor and a long pallet being pushed by a powered industrial truck (PIT). The employee sustained an ankle fracture and was hospitalized.

A tow truck operator was operating his bed controls on the drivers side when another vehicle crashed into him. The employee sustained fractures to the right femur, hip, and left foot, as well as abrasions to the right knee and a laceration to the right wrist.

An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.

An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.

An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.

An employee fell from a dock to ground level (less than 4 feet) and broke their tibia/knee.

An employee was on the ground working to close a trailer door. The door was caught by the wind and blew the employee backward. He landed on his back and sustained four fractured ribs, requiring hospitalization.

An employee was walking on top of boiler to close a valve. The employee fell off the boiler and landed on the floor, sustaining fractured ribs. The employee was hospitalized.

An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.

An employee's left bicep was lacerated by high-pressure water during water blasting operations. The employee was hospitalized.