Injured by handheld object or equipment, n.e.c. · Puncture wounds, except gunshot wounds
At a glance
Federal OSHA recorded a severe workplace injury
at Cargill Meat Solutions Corp, 1252 PA 706, WYALUSING, PENNSYLVANIA 18853
on — Puncture wounds, except gunshot wounds, affecting the hand(s), unspecified.
Final narrative
An employee was cleaning a small piece of equipment using a powered rotary wire brush when a piece of wire went through his glove and became stuck in his left hand. His hand became infected and required hospitalization.
An employee had been loading meat trays on a conveyor belt. After finishing, the employee's finger became caught between the conveyor and a table leg, resulting in a partial amputation.
An employee was using a yard horse to dump a trailer's load into a raw material bin. The crank on the trailer came loose and struck the employee in the head, causing a fractured skull.
An employee was in the process of removing a label from a combo. The employee moved to get out of the way of a forklift when the rear of the forklift contacted the combo and the employee's left hand was caught between the combo and the forklift. The employee suffered an open fracture to the distal left phalanx and to the thumb.
An employee was operating a side puller that removes animal hides when his hand was caught in the gripper, resulting in amputations of the fourth and fifth fingertips.
An employee was using a circular saw to cut flashing. He was finished with the cut and started walking away when his fall protection ropes became entangled in the saw and the saw was pulled into his leg. The employee sustained a left hamstring laceration.
An employee had finished sharpening a knife on the grinding wheel and was returning it when he lost grip of the handle. As the employee reached to catch the it, his abdomen was lacerated by the knife blade in the right lower quadrant.
An employee was removing an ambulance off a lift jack when the pressure against the jack caused the handle to kick upward, striking the employee on the left side of the head, neck, and jaw. The employee suffered injuries that required hospitalization.
An employee was installing a flange on an evaporator skid. The employee was holding the bar of a torque wrench when his hand was caught in the pinch point as another employee turned the wrench. He suffered a right middle fingertip amputation.
An employee was using a hand grinder to eliminate discrepancies on columns around the project when the grinder jumped and came out of the employee's hands. They sustained a little finger amputation.
More severe injuries in this industry (NAICS 311611)
An employee was scraping dried glue from the top lid of a hot glue pot. His left hand slipped and came into contact with the hot glue. He then suffered burns to his hands and fingers as he tried to remove the glue. He was hospitalized.
An employee was in a scissor lift approximately 20 feet above the ground to place a plastic tarp on a catwalk in order to catch condensation. They positioned the lift opposite the work area and stepped out of the scissor lift onto an I-beam. The employee fell from the I-beam to the ground. The employee was hospitalized with a skull fracture on the right side of their head and injuries to the chest and both eyes.
A maintenance employee was called to look at a pallet conveyor machine where a chain had fallen off a sprocket wheel. When the employee grabbed the loose chain, a light sensor caused the machine to restart. This created a pinch point between the chain and sprocket that caught the employee's left little finger. The finger was surgically amputated at the second knuckle.
The injured employee was standing by one of the stationary computers along the wall. There was a half-pallet located approximately 3 feet behind the employee that consisted of 12-pound boxes stacked six boxes high. A forklift was transporting a pallet that came in contact with the stationary pallet behind the injured employee, causing four boxes to fall and contact their legs. The injured employee was hospitalized with leg injuries.
An employee was using a box strapping machine to place straps on boxes when his right middle finger was caught in the machine, resulting in an open fracture to the distal phalanx.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.