Pedestrian struck by vehicle or object propelled by another vehicle in nonroadway area · Traumatic injuries or exposures unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at JBS Souderton, Inc., 249 Allentown Rd., SOUDERTON, PENNSYLVANIA 18964
on — Traumatic injuries or exposures unspecified, affecting the Leg(s) unspecified.
Final narrative
The injured employee was standing by one of the stationary computers along the wall. There was a half-pallet located approximately 3 feet behind the employee that consisted of 12-pound boxes stacked six boxes high. A forklift was transporting a pallet that came in contact with the stationary pallet behind the injured employee, causing four boxes to fall and contact their legs. The injured employee was hospitalized with leg injuries.
Hospitalized Leg(s) unspecified Forklift, order picker, platform truck powered
An employee was blowing steam into the lines of a tank to unclog them when the sediment tank overflowed. The employee sustained second degree burns on their right arm from the wrist to the elbow, and sustained second degree burns on their left arm from the wrist to the shoulder.
An employee was removing a large auger from a meat grinding machine when the auger slipped out of the lifting device and onto the employee's leg. He sustained a leg fracture.
An employee was attempting to remove a plastic bag from inside a piece of equipment. A small serpentine belt inside of the unit activated, pulling her sleeve and right arm into the machine. The employee sustained a fracture and a laceration to her lower right arm.
An employee was moving cattle from pen to pen in a barn. A steer became agitated and head-butted the employee's upper right thigh. The employee suffered a contusion and swelling to the thigh.
The injured employee was walking through the warehouse. Another associate was driving a forklift with a pallet of large format tile (slabs) when the slabs began to tip. The injured employee ran over to stop the slabs from falling, but the slabs fell on his lower left leg/foot. The employee sustained fractures in his lower leg and foot. He was hospitalized and required surgery.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was helping offload an aircraft. She was standing in the opening between a parked cart and an unoccupied aircraft tug when another vehicle struck a stationary bag cart, which then struck her. The employee suffered a skull fracture near the right eye, a right kneecap fracture, a nose fracture, and sinus damage, as well as soft tissue damage to the left calf and hip. She was hospitalized and required surgery.
An employee was cutting steel channels from a hanging rack that was being supported by a forklift. When they were finished, the forklift started moving the rack out of the area and a piece of material snagged one of the rack legs, causing the rack to tilt backward. The rack slipped off the forklift and struck the employee on his right side/lower back. He sustained a fractured pelvis and was hospitalized.
An employee was inspecting a direct-current cable that was going to be pulled with the help of a vehicle. The cable was made from two cables coupled together that each measured 2 inches in diameter. The cable came free of its pulley and struck the employee's left ankle, resulting in a fractured ankle and injured thumb.
More severe injuries in this industry (NAICS 311611)
An employee was scraping dried glue from the top lid of a hot glue pot. His left hand slipped and came into contact with the hot glue. He then suffered burns to his hands and fingers as he tried to remove the glue. He was hospitalized.
An employee was in a scissor lift approximately 20 feet above the ground to place a plastic tarp on a catwalk in order to catch condensation. They positioned the lift opposite the work area and stepped out of the scissor lift onto an I-beam. The employee fell from the I-beam to the ground. The employee was hospitalized with a skull fracture on the right side of their head and injuries to the chest and both eyes.
A maintenance employee was called to look at a pallet conveyor machine where a chain had fallen off a sprocket wheel. When the employee grabbed the loose chain, a light sensor caused the machine to restart. This created a pinch point between the chain and sprocket that caught the employee's left little finger. The finger was surgically amputated at the second knuckle.
An employee was using a box strapping machine to place straps on boxes when his right middle finger was caught in the machine, resulting in an open fracture to the distal phalanx.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.