Almetek

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was operating a hand-powered drill to drill holes into plastic clips. The drill bit snagged on a plastic clip and spun the clip around, resulting in an a laceration to her left index finger that required surgical amputation.

An employee was using a table saw to make a dado cut on a piece of wood. The piece of wood contacted the blade, which pulled in the employee's hand. The blade severely cut the employee's left palm.

An employee was shearing sheet metal with a shear machine activated by a foot peddle. When he hit the foot pedal, one of the springs crushed his finger, resulting in a partial fingertip amputation.

An employee was disengaging a utility trailer wheel jack and hitch when his right ring fingertip was pinched and amputated.

An employee was working on a motorized screen when they fell approximately 3 feet from a step ladder to the ground. The employee sustained a face contusion and a fractured jaw.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.