Dead River Company

An employee tripped on his cane and hit his head on a cabinet.

An employee was repairing an underground gas main when natural gas ignited and an explosion and fire occurred. The employee sustained burns.

An employee was lighting the pilot light on a water heater. Gas ignited, causing a flash fire and explosion at the residential property. The employee suffered burns to the head, neck, upper torso, and upper extremities.

An employee was preparing a reach in cooler (fry cooler) and charging the system with refrigerant (R290)with his gauges. When the employee removed the gauges from the liquid line service valve, the refrigerant immediately escaped, and the liquid refrigerant exploded due to an unknown ignition source. The employee was burned on the face, hands, abdomen and knees.

An employee was lighting a gas stove/pizza oven when an explosion occurred due to a natural gas buildup. The employee sustained first- and second-degree burns to the face, neck, arms, hands, and legs.

An employee was re-lighting a sulfur burner while another employee increased the pressure on the gas valve. A gas explosion occurred. The employee sustained second-and third-degree burns to their arm, hand, chest, abdomen, and neck.

An employee was on top of a fuel truck filling it up when the fueling arm swung around and knocked him to the ground. The employee was hospitalized with fractures to the ribs and pelvis.

An employee was unjamming a wood cutting/wood splitter machine when it amputated the employee's hand.

An employee tripped on his cane and hit his head on a cabinet.

An employee was adjusting a conveyor. The employee's right foot fell through a top plate and was injured by the conveyor.

An employee was power-washing a concrete drive. Water from the high-pressure power washer tore through his clothes and cut deeply into the skin, muscle, and ligaments of his leg and knee. He was hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.