NMC-Wollard, Inc.

An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.

An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.

An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.

During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.

An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.

An employee was using a punch and hammer to remove a pin from the mast of a forklift. The mast was secured by an overhead crane. The mast shifted, and the employee's thumb was pinched between the mast and the punch, resulting in an amputation to the tip of his left thumb.

On September 22, 2025, an employee tripped and fell over a permanent fixture (angle iron) that serves as a parking block in the back of a facility. He suffered a fractured right hip and was hospitalized.

An employee was helping a customer with repairs on their trailer. While lowering the ramp door of the trailer, the customer dropped the door and it contacted the employee's left ring finger, resulting in a fingertip amputation.

An employee was working to lay a part in the vise of the band saw in preparation for cutting. The left vise closed, pinching his fingertips against the part. The employee's middle and ring fingertips were amputated and they sustained a laceration to the index finger requiring stitches.

On April 8, 2025, an employee entered an engine test cell to de-harness an engine and was exposed to hot water resulting in burns and hospitalization.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.