Struck by swinging or slipping object, other than handheld, n.e.c. · Multiple traumatic injuries and disorders, n.e.c.
At a glance
Federal OSHA recorded a severe workplace injury
at Florida's Frame Pro Carpentry, Inc., 600 Lambert Ave., FLAGLER BEACH, FLORIDA 32136
on — Multiple traumatic injuries and disorders, n.e.c., affecting the multiple body parts, n.e.c..
Watch Florida's Frame Pro Carpentry, Inc. — freeGet an email when a new federal OSHA severe-injury report for Florida's Frame Pro Carpentry, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
On January 31, 2018, at 11:30 a.m., an employee was struck on the left wrist and the left side of his torso by the end of a truss that broke in half as it was suspended from a crane. He suffered a bone bruise to the left hand, torn left rotator cuff, three broken ribs, and a hematoma of the left lung, requiring hospitalization.
HospitalizedMultiple body parts, n.e.c.Roof trusses, joists
More severe injuries at Florida's Frame Pro Carpentry, Inc.
An employee was installing roof trusses on a new building. While standing on a masonry concrete wall, he fell 12 feet to the ground, injuring his spleen, ribs, and right leg. He was hospitalized.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 238130)
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was on a 6-foot ladder, working to nail a 2-by-4 on a hotel carport ceiling. He lost his balance and his muddy boots slipped. He then fell and his foot lodged in the ladder. His foot was broken in two places and he was hospitalized.
An employee was installing a ceiling joist for a residential home when they fell from a framing structure and landed on the ground 8 feet below. The employee's right arm was fractured.
On September 16, 2025, a employee was moving a dolly with seven drywall sheets. The wheel of the dolly got stuck. The material tipped over and fell onto the employee's left foot, fracturing their tibia.
An employee was installing 80-foot-long trusses onto a 150-foot by 80-foot post-frame building. The employee worked from the north lift and then on the trusses about 20 feet up to install bracing. While installing diagonal bracing on the top chord, the trusses collapsed, causing the employee to fall approximately 20 feet to the concrete and be struck by the falling trusses. The employee was hospitalized with a fractured pelvis and a concussion.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.