Contact with hot objects or substances · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Eastern Alloys, Inc., 11 Henry Henning Drive, MAYBROOK, NEW YORK 12543
on — Heat (thermal) burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
An employee was pouring sows (molten metal) into a mold when the metal blew out, resulting in burns to the neck, chin, and hands.
HospitalizedMultiple body parts, n.e.c.Molten or hot metals, slag
An employee connected a steam line to a hose to clean equipment when the fitting broke loose. They were struck by steam in the left inner thigh, resulting in burns that required hospitalization.
An employee was making tea when she noticed tea grinds were collecting on the side and water was no longer dripping through the funnel. The employee was checking the funnel when boiling water and tea grinds spilled onto the left side of her body. The employee sustained burns to her neck, back, and arm.
An employee had turned off the ball valve on a waterpipe system and was removing the plug when the coupling system attached to the strainer came apart. Hot water sprayed on his arm and back, resulting in first- and second-degree burns that required surgery.
An employee was using a shovel to remove waste vermiculite from molten zinc. The metal had been placed in a bin and partially hardened. The employee broke through the partially hardened metal; still-molten metal flowed to the employee's steel-toed right boot and entered through the cloth boot tongue. The employee suffered a third-degree burn to the right foot and was hospitalized.
More severe injuries in this industry (NAICS 331492)
An employee was monitoring a conveyor at the operator station. A piece of metal was fed to a conveyor system and it struck another piece of metal, causing a piece of titanium (1-inch-long and 1/2-inch-wide) to break off and strike the employee in their upper chest below the clavicle. The employee was hospitalized and the embedded piece of metal was surgically removed.
An employee was working by the slag side of a reverb in the furnace department. They returned home after the end of their shift and began feeling muscle cramps, resulting in hospitalization due to dehydration.
An employee had been working in the refinery area of the facility. He then began to feel dizzy and suffered other heat illness symptoms. He was hospitalized for possible heat stress.
On May 14, 2025, an employee was sitting cross-legged and removing a pneumatic rail car vibrator from its bracket to empty the next pocket in the rail car. When the employee went to set the vibrator down, he placed it on a hammer that was sitting in front of him and the vibrator teetered to the side, catching his little finger. The employee sustained an amputated fingertip at the first knuckle.
An employee was opening a railcar compartment using a wrench when the tool broke and the employee slipped and fell to the same level. The employee sustained a fractured lower right leg.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.