Caught in running equipment or machinery during maintenance, cleaning · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Eggers Industries, Inc., 164 N. Lake Street, NEENAH, WISCONSIN 54956
on — Soreness, pain, hurt-nonspecified injury, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was using a scrub pad to clean the drip tray underneath two moving rollers when the employee's right hand was pulled into the rollers, causing soft tissue damage to the right middle, ring, and pinky fingers.
HospitalizedFinger(s), fingernail(s), unspecifiedOther special process machinery, unspecified
On June 28, 2021, at 8:45 a.m., an employee went to dislodge a door from a double-end trim saw when his hand contacted the saw blade. The employee suffered a partial amputation of the right index finger down to the top knuckle, as well as lacerations to two adjacent fingers,
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321918)
A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.
An employee was adjusting the height of an ultraviolet (UV) lamp. She was electrocuted by the UV machine. She sustained burns on her left hand and an entry wound on the right forearm. The employee was hospitalized.
On August 14, 2025, an employee was rebuilding a tile-cutting die when their right wrist contacted the cutting blade, resulting in a laceration that required hospitalization.
An employee was removing a jammed piece of scrap wood from the end of a machine saw when the wood pulled their right hand into the saw blade, resulting in an index finger amputation below the second knuckle.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.