Nabors Drilling Technologies USA, Inc.

An employee was inserting drilling slips in a wellbore. The drill pipe separated, moved within the wellbore, and struck the employee's head. The employee suffered head trauma.

An employee was applying thread protector covers and moving the floor wrench into a stow position so they could lay pipe down. The wrench crushed the employee's hand between the wrench housing and a pipe.

An employee connected a pipe elevator to a drill string. The pipe elevator unlatched while the string was being lifted. The elevator struck the employee causing a fracture and dislocation to their right elbow. The employee was hospitalized.

An employee was removing tubulars from a mousehole but the slips did not release from the tubular until it was raised. When the slips released, they slid down the tubular and struck the employee in the head. The employee sustained a back injury, a head laceration, and a fractured rib.

An employee was climbing the derrick girt to perform work on a cover. As they went to tie off the top drive, the driller came down with the top drive pulling the employee off the girt and onto the top drive. The employee sustained fractures to the pelvis and tailbone.

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

An employee was acting as a spotter for a forklift operator. While its forks were being raised, the forklift came into contact with a power line. The employee was touching the forklift's metal frame at the time and was shocked on the left palm. The employee suffered burns to both the left palm and the sole of the left foot.

An employee was leaning down to install conduit. When he stood up, a 2-inch all-thread rod caught and lacerated his left eyelid.

An employee was working as a fire watch. The employee was exposed to anhydrous ammonia and was not able to see while climbing down a ladder due to eye irritation. The employee fell and was hospitalized for a broken ankle.

An employee was standing on the ground awaiting the lowering of a pipe. After the pipe was lowered to the ground by a skid steer, it rolled and struck the employee's left leg. The employee was hospitalized with a fractured leg.

An employee was tightening a gas pipe with a wrench when the wrench slipped from his hand. The employee's arm then hit a metal cross-brace, resulting in a lacerated arm.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.