An employee was walking near a railing system used to move large parts along a trailer manufacturing production line when a trailer's sub frame weighing 200 to 300 pounds fell off the railing and struck the employee. The employee suffered broken metatarsal bones and required hospitalization.
HospitalizedFoot (feet), n.e.c.Vehicle and mobile equipment parts, n.e.c.
An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.
An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.
An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.
An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.
More severe injuries in this industry (NAICS 336212)
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was assisting with rigging a magnet to an overhead crane in order to lift a sheet of steel. The employee's right thumb was between the crane's hook and the chain passing through the hook, and when the crane was raised, the distal end of their thumb was crushed. Part of the employee's right thumb was medically amputated.
Two employees were working together to insert a pin into a hydraulic cylinder. One employee was holding the cylinder in place to align it with the pinhole, while the injured employee was inserting the pin. The injured employee was aligning the pin and moved to determine whether the hole alignment was too high or low. At that moment, the crowbar being used to assist with alignment slipped and his left index fingertip was pinched between the cylinder and the housing, resulting in an amputation just below the fingernail.
An employee was hoisting an axle in the buggy department when one side of the sling came loose, causing the axle to tip. The sling hook raised up from the weight transfer, causing the employee's left little finger to be caught by the rigidness of the hook. The fingertip was amputated.
An employee was using a circular saw to cut the cap off an aluminum bulkhead of a trailer that was being manufactured. The saw kicked, lacerating his hand and resulting in the amputation of his left middle and ring fingertips.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.