Quality Paints & Coatings

An employee was installing wood trim surrounding a skylight inside a home. While holding a piece of trim in it's desired location, his pneumatic nail gun discharged, sending a 3/4-inch pin nail into his left forearm.

An employee removed a safety valve on a trailer that unknowingly contained nitrogen gas. The gas released from the trailer and pushed the employee backward off a scaffold approximately 10 feet before they struck a garage door, resulting in a pelvic injury.

An employee was sitting at her workstation when a nail gun malfunctioned and shot a nail into her left leg. She suffered a puncture and blood vessel injury and was hospitalized.

On November 25, 2023, an employee was using a high-pressured water hose to perform sewer line cleaning operations. The employee's right little finger and palm were lacerated by pressurized water from the hose.

An employee was hydroblasting when they slipped and the pressurized water stream lacerated their left ankle.

An employee was operating a shear to cut metal parts when two of their fingers contacted the blade. This resulted in amputation of the left middle and index fingertips.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.

A maintenance employee was climbing a fixed roof access ladder to perform work on an HVAC unit when they fell from the ladder, over the second-floor railing, and onto the stairs below. The total distance of the fall was over 20 feet. The employee suffered multiple fractures that required hospitalization.

At about 8:00 p.m. on September 8, 2025, an employee was cleaning an extruder. While he was brushing built-up powder, his hand brushed the extruder screws. The screws caught his right index finger and amputated about a quarter inch of it.

At about 10:30 a.m. on August 7, 2025, a warehouse technician working for Tnemec Company, Inc., began sweating profusely a half-hour into their shift. The employee was using a forklift to move staged pallets of paint to a shrink-wrapper, shrink-wrap the pallets, and then load the pallets onto a truck using a forklift. The employee became ill about two hours later and was hospitalized for heat-related illness.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.