Baker Hughes

An employee was walking into a room and tripped on the tile floor. He lost his balance and fell onto his left side, fracturing his left femur bone.

During routine maintenance of the bonnet end cap on a blowout preventer, the cap fell and smashed an employee's right ring finger against another ram bonnet. The finger was amputated.

An employee was positioning an oilfield drill bit when it fell from the connection fixture it was connected onto. The bit fell onto the employee's left ring fingertip and crushed it against the work surface. The fingertip was medically amputated.

An employee was acting as a spotter and guiding a flatbed operator while standing on the rear passenger side of an outrigger leg when he stepped back onto a mobile crane platform and fell approximately 70 inches to the ground. He was hospitalized with an open fracture to the left ankle.

An employee was moving an electric motor on a shelving unit when the motor began to roll. The employee tried to stop the motor from rolling by placing a wedge under the motor and got his finger caught between the motor and the shelving unit resulting in amputation of an index finger.

An employee was picking up some brick that had fallen by the roller track. He walked under the packaging exit rollers and struck his head on a crossbar, sustaining a concussion and whiplash.

An employee was getting out of a yard truck to go into a warehouse to get paperwork when his left calf was caught on the hook attached to the truck's battery box. The employee sustained a laceration.

An employee was inspecting a drip coming from a water line. The employee bumped his head on a compressed air storage tank and sustained a concussion, neck strain, and injured disks in the lower back. The employee was hospitalized.

An employee was cleaning a vehicle when their left thigh struck the corner of a stone column, resulting in swelling that required hospitalization and surgery.

An employee was manually moving empty pallets in a warehouse. The employee struck their head on a racking system, suffered head injuries, and was hospitalized.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.

An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.

An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.

An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.