Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Norlen, Inc., 900 Grossman Dr., SCHOFIELD, WISCONSIN 54476
on — Amputations, affecting the fingertip(s).
Watch Norlen, Inc. — freeGet an email when a new federal OSHA severe-injury report for Norlen, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was operating a press brake. The employee placed the part into the brake press opening to the backstop and actuated the ram lowering it onto the part. The employee's left hand then slipped forward off the edge of the part and up against the front of the punch where two fingers were pinched between the part being folded upward and the upper die surface. The fingertips were amputated and surgically reattached.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332323)
A temporary employee was performing a two-person projection welding task to add a hinge reinforcement to a hollow steel door. He was positioning the hinge reinforcement while his supervisor held the door to maintain alignment. When the foot pedal was actuated, the electrode partially amputated the employee's left ring finger.
An employee was stacking bundles (12 feet long, 21 inches high) of aluminum extrusions (weighing 28 pounds each). After three bundles had been successfully stacked, the fourth tipped over when it was partially complete. It landed on the employee's right ankle/leg and broke the tibia. The employee was hospitalized.
An employee was adjusting the rollers on the mill feeder when their right thumb was crushed between two rollers, resulting in amputation of the thumb tip.
An employee was operating a core drill to bore through concrete at an active construction site. The equipment struck embedded rebar in the concrete, causing the handle to kick back and strike the employee's ribs. The employee was hospitalized with a fractured rib and a punctured lung.
An employee was loading pallets onto a truck and climbed down off a pallet after loosening straps to release the crane. The employee slipped off the flatbed truck and fell 4 feet to the dock plate/ground. The employee was hospitalized with a brain bleed and fractures to their T4, T5, and T6 vertebrae.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.