LM Wind Power

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

Two employees were hospitalized for electrical shock and burns after contacting energized electrical components of a turbine system.

Four employees were traveling in a utility task vehicle (UTV) on the east lot of the site. While turning, the UTV flipped over onto the driver's side. The driver's left wrist and hand were crushed by the frame of the UTV resulting in a fractured and dislocated wrist, as well as hand injuries. The driver was hospitalized and required surgery.

On August 15th, 2025, an employee was aligning/connecting a coupler to the generator of a wind turbine. The coupler was secured in place by a strap that was connected to the turbine's chain hoist and a bolt. While lining up the remaining holes, the coupler rotated while the employee's right index finger was in one of the bolt holes, causing a partial amputation through the phalanx.

Employees were preparing to unload a wind turbine gearbox from a flatbed trailer. An employee went to reposition himself on the flatbed trailer and grabbed onto a wooden piece of the shipping cribbing for support. The piece of wood began to come loose, causing the employee to lose his balance. The employee jumped to the ground about 4 feet below and landed on his feet. His left ankle rolled and the employee was hospitalized with a fractured ankle that required surgery.

An employee was working to move a paper roller carriage, which is a 3 by 3-foot paper roll weighing approximately 500 pounds. The employee's hands were positioned in the area where the spool meets the cradle. As the employee moved the carriage across a floor track, the paper roll was dislodged and caught the employee's finger, severing it. The employee's right middle fingertip was partially amputated.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.