EATON CORPORATION

A maintenance technician was cleaning a piece of equipment that is used to pump grease when their hand became caught between a pulley and belt on the equipment. The employee sustained a right middle fingertip amputation.

An employee was working on a jet wheel blaster and putting dies into the machine when their thumb was caught between the moving table and a fixed part. The employee sustained a crush injury to the finger.

An employee was maneuvering steel bundles supported by an overhead crane. The employee's right hand was caught under or beside the bundle, and a fingertip was amputated at the last knuckle.

An employee was doing electrical work. An arc flash caused the employee to suffer third-degree burns to the chest and hands.

An employee had three baskets of parts stacked on a work table. The top basket slid off the table and lacerated her right thigh.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was preparing to cut rubber stock on a pneumatic cutting machine when their middle and ring fingertips were amputated by the cutting blade.

At about 12:25 a.m. on September 3, 2025, an employee was troubleshooting a malfunction involving a slitter whose arbor was not rotating as expected. The employee was observing the slitter's operations when the arbor completed its cycle and the employee's right index finger was drawn into the slitter's 4-inch, non-rotating cutting blade. The fingertip was amputated.

An employee was operating a rolling rope machine. Tooling fell out of the machine and landed on the employee's foot, breaking bones. The machine was not guarded at the time.

An employee was operating a machine when hot air and water was released. The employee sustained burns to the neck, back, buttocks and leg on the right side.

An employee was operating a slitter machine when the roller bar amputated the tips of their right middle, ring and little fingers.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.