Struck by falling object or equipment, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at WEEKS MARINE INC., 1868 Dr. Beatrous Road, THERIOT, LOUISIANA 70397
on — Amputations, affecting the arm(s), unspecified.
Final narrative
An employee was removing a large hydraulic ram to gain access to a hydraulic leak when he unbolted the cradle and it fell out, pinning him against a steel bulkhead. He suffered an amputation to his right arm.
HospitalizedAmputationArm(s), unspecifiedParts and materials, unspecified
A maintenance employee was working on a barge in open water, replacing the belt on a deck winch. After replacing the belt and testing it, the employee was taking a picture of the model number on the belt when the machine started. His hand was pulled into the belt and pulley, resulting in a partial amputation to his index finger.
An employee was standing alongside a slip, with a mooring line next to the cleat, attempting to catch/slow down a barge and tie it up. The mooring line grabbed the employee's right heel and pulled it into the cleat, causing compound fractures to the right tibia and fibula and severe ankle lacerations.
An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.
An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.