H.C. STARCK, INC.

An employee was polishing a metal bar on a manual lathe with an emery cloth when the cloth became caught around the rotating bar, consecutively catching the employee's glove. The lathe was rotating at 566 rpm at the time of the incident. The employee's right index finger was amputated to the first knuckle.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee was performing maintenance on the second level of a silo. While they were making sure the belt pulley were not seized up, the belt was powered on, causing the employee's finger to get caught in the sheave. Their left little finger was partially amputated.

An employee was operating a table saw to cut pieces of lumber measuring 2x2x36 inches. The blade contacted the employee's left thumb, cutting half of the distal phalange bone and amputating the thumb tip along the bottom of the fingernail.

A temporary employee was wrapping a chain around a 2,000-pound block of metal, located on the ground. The block tipped over and crushed his right foot. He was hospitalized, requiring surgery.

An employee was observing the clean-up process of a spilled ladle. As the employee was walking away from an area of cooling metal, there was an eruption due to molten metal reacting with water. The employee fell forward, attempted to catch himself, and his right hand touched the molten metal resulting in burns to the little fingertip and middle finger.

An employee was helping unload a skid steer off a truck skip. While positioned with his left foot on the skid steer's step and his right foot on the tire, he was helping unhook the chains from the truck skip and slipped and fell backward, landing on the rear rail of the truck skip. He suffered six broken ribs and a flail chest injury.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.