Williams Form Engineering

An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.

An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.

An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.

During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.

An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.

An employee was shoveling excess material (spillage) that consisted of dry mix, sand, aggregate and cement. As he was shoveling, some material blew back in his face and around his safety glasses. He got a piece of metal in his left eye that required surgery. The employee was hospitalized.

An employee was spotting the dust auger as it was lowered onto the trailer so that it would not contact a piece of equipment already on the trailer and pinch electrical cords. As the auger was being moved into place horizontally, his thumb was caught between two brackets, one on the auger and one on a piece of equipment already on the trailer. The employee sustained a partial amputation to the left thumb.

A temporary employee was bending rebar on a bending table (machine) when his right little finger got caught in the rollers. The employee sustained an amputation down to the first knuckle below the fingernail.

At 10:00 a.m., an employee was preparing to cut lumber for an A-frame structure using a compound miter saw when the saw kicked back and contacted his left hand. The employee sustained complete amputation of the thumb and a partial amputation of the index finger.

An employee was unloading a bundle of quartz slabs from a truck bed using a forklift and lifting slings. The employee was standing on the truck bed to secure the slings to the bundle when one of the two A-frames supporting the bundle fell over. The employee jumped off the truck bed to avoid being hit, causing them to strike the ground and sustain fractures to their left hip, femur, and elbow.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.