Hillendale Farms

An employee was walking in an aisle when a forklift backed up over her foot, resulting in a skin injury that required surgery to repair.

An employee was looking into the bucket of a front-end loader to see how much material was in it. A skid steer backed into the employee, who then fell into the edge of the front loader's bucket and suffered internal bleeding in the abdominal area.

An employee was spotting for a forklift operation. The forklift backed over the employee, who suffered a complete amputation to one lower leg and a partial amputation to the other leg. The employee was hospitalized.

An employee was cleaning his work area and preparing it to begin making air-set molds when a nearby forklift that was backing out from a load swung around and struck the employee. They sustained a lower left leg fracture.

An employee was walking around a work area when he was struck by a forklift that was backing up, resulting in several broken bones in his foot.

Three employees were transferring a metal lid using a manual chain hoist to place it onto a cart. While they were adjusting its position, the lid shifted and the injured employee's left hand became caught between the hoist hook and the handle, resulting in a laceration and amputation of their ring fingertip including the tuft.

An employee was using an 8-foot metal pipe to remove a manure blockage at the transfer to an incline conveyer. The employee s left hand was placed on top of the pipe while removing the blockage. The pipe pushed their left hand into the wooden railing of the platform they were standing on, catching their thumb in a pinch point and resulting in partial amputation.

An employee was driving a farm truck with the dump box raised when he went through a farm building accessway and the dump box struck the entryway of the building. The truck lifted up and came back down, jolting the employee. The employee sustained a back injury.

An employee was doing housekeeping work inside a chicken house. The employee missed a step onto a walkway near the exit, fell into an 8-foot-deep pit, and landed on its concrete floor. The employee suffered a leg fracture above the ankle, as well as a chin laceration.

An employee was troubleshooting a manure belt to figure out why it kept turning off. The employee's right hand was pulled into the drive and compression roller of the long belt in the manure belt system, resulting in numerous injuries to their hand and forearm, including a partial amputation of the middle finger and a degloved palm.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.