Carpenter Technology

An employee was unjamming and realigning steel bars on a bar straightener. Her left hand was caught between a steel bar and a roller, and the middle fingertip was amputated.

An employee was struck on the lower leg by an ingot that fell from a crane. The employee's right lower leg was fractured.

As an employee was loading a large piece of scrap into the scrap drum, the scrap fell from the hoist and tipped the scrap drum over. This pinched the employee's leg between the drum and an adjacent remelt bloom. The employee sustained a right calf contusion.

An employee was cutting wires, working from a ladder. A piece of skull from a furnace fell and struck the ladder. The employee fell from the ladder onto a scrap bin, suffering broken ribs.

An employee was working to reposition an exhaust hood. The hood fell over and the employee sustained an ankle injury.

On December 26, 2023, an employee went out to the parking lot to troubleshoot the starter of an SUV. The employee was underneath the vehicle when it started and moved and the employee's middle back area was caught under the front passenger-side tire. The employee sustained a fractured collar bone.

An employee was parking at a patient's home and exited the van to manually open the garage door. The van began rolling backward and rolled over the employee's right leg. She was hospitalized with a fractured leg.

A driver exited their truck so they could provide service for a customer when the truck began to roll away. The driver went to re-enter the truck but fell and was struck by the rear driver-side tire. The employee sustained fractures to their leg and foot.

An employee had been operating a yard tractor. He parked the vehicle and was exiting when the vehicle began to roll, causing him to fall. The employee's hand was then run over by the yard tractor, resulting in fractures to multiple fingers. The employee was hospitalized.

An employee was checking for a leak in the air brake system of a semi-truck. The employee had removed the brake chamber when the truck rolled back. One of the tires pinned the employee's right hip against the ground.

An employee fell while entering the building. The employee was hospitalized with a fractured ankle and required surgery.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was working to close a furnace door. The hydraulic mechanism that opens and closes the furnace door was non-operational and had been disconnected to allow the furnace door to be opened manually. As the employee was releasing the pins that held the door open, the door and the hydraulic cylinder fell, pinching their left hand between the hydraulic cylinder's base plate and the furnace. The employee suffered amputation of the little fingertip.

A rolling mill was shut down due to a cobble between two mill stands. The injured employee was cleaning the cobble from the delivery side of stand A, while another employee went to the control panel to move stand B and stand A moved instead. The injured employee's right thumb got caught between the delivery guide of stand A and the looper trough. The tip of his thumb required surgical amputation to the bone to allow for stitches.

An employee was helping another employee load stock material onto a press brake when the stock slipped. The injured employee's right index finger was caught between the press brake die and the stock, resulting in amputation at the first knuckle.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.