Struck by discharged object or substance · Burns and other injuries, n.e.c.
At a glance
Federal OSHA recorded a severe workplace injury
at Vertex Aerospace, LLC, 795 Lockhart St., Bldg 640, COLUMBUS AFB, MISSISSIPPI 39701
on — Burns and other injuries, n.e.c., affecting the multiple body parts, n.e.c..
Final narrative
Three employees were repairing an aircraft ejection seat when it fired and ejected from the aircraft. One of the employees was hospitalized with burns and lacerations to the face, arms, and chest.
HospitalizedMultiple body parts, n.e.c.Vehicle and mobile equipment parts, n.e.c.
An employee was installing wood trim surrounding a skylight inside a home. While holding a piece of trim in it's desired location, his pneumatic nail gun discharged, sending a 3/4-inch pin nail into his left forearm.
An employee removed a safety valve on a trailer that unknowingly contained nitrogen gas. The gas released from the trailer and pushed the employee backward off a scaffold approximately 10 feet before they struck a garage door, resulting in a pelvic injury.
An employee was sitting at her workstation when a nail gun malfunctioned and shot a nail into her left leg. She suffered a puncture and blood vessel injury and was hospitalized.
On November 25, 2023, an employee was using a high-pressured water hose to perform sewer line cleaning operations. The employee's right little finger and palm were lacerated by pressurized water from the hose.
Two employees were removing a service lift platform from the back of a radar system. While handling the service lift platform, employee 2 was standing on the back of the radar and lost their footing, causing the service lift platform to shift and fall. The injured employee then fell from the top of the platform electronic subsystem (PES) to the floor, approximately 56 inches. The injured employee fractured his left elbow and left hip.
On June 27, 2025, an employee was walking out of the hangar when he tripped and fell on the concrete ramp. He sustained lacerations to his right elbow and right hand, and was hospitalized with a fractured right hip.
An employee was performing maintenance activities on a ladder when they fell approximately 46 inches to the ground, resulting in a fracture to the left pelvis/sacrum.
An employee was loading a 150-pound block of aluminum into a CNC machine when their right hand was struck by the block. The employee sustained a fracture and severed tendon to the index finger, as well as a laceration to the middle finger that required stitches.
An employee picked up material out of a cardboard box that was on the floor. As he was carrying the material, he stepped backward and tripped over the cardboard box, causing him to fall and suffer a compound fracture of his leg.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.