Kinetics Noise Control

On or about 7/22/2015, at approximately 5:15 p.m., an employee was using a shear saw to cut fiberglass blocks when the employee's finger contacted the saw blade. The employee had four fingers on one hand amputated and three fingers on the other hand amputated. The employee was hospitalized.

An employee was moving a piece of an I-beam for welding when it rolled off the cribbing. The employee went to catch it when it fell and crushed the employee's finger, resulting in a partial amputation.

An employee was helping to disassemble large reels used to store steel wire when a 264-pound flange from the reel fell over onto the employee's left leg. The employee sustained multiple fractures to their leg and ligament injuries to the lower leg.

The injured employee was putting away materials on the warehouse floor as a co-worker was pushing a pallet onto a nearby shelf. The pallet knocked another pallet forward, causing it to fall onto the injured employee's shoulders. The employee suffered fractures in their right and left knees and ankles.

Employees were moving a single man lift into a building and reclining the lift to position it to fit through the door. The lift shifted and fell, causing the employee to sustain fractures to the left tibia and fibula. The employee was hospitalized and had surgery.

An employee was moving a light tower so it could be hitched to a truck. He grabbed the tongue of the trailer hitch on the light tower to slide it to the left. The tongue jack fell off, causing the light tower tongue to drop on the employee's right hand. The employee's middle fingertip was amputated.

The belt on an air compressor had just been put back into place after turning upside down. An employee was working to take a picture of the identifying numbers on the belt so that a replacement could be ordered when the compressor rolled, causing the pulley to spin. The employee's right index finger was caught between the pulley and the belt, and the fingertip was amputated at the first knuckle.

An employee was receiving a 660-pound beverage vending machine for repair. While the machine was being moved from the back of the van to the lift gate, the caster wheel was caught between the van and the lift, causing the machine to fall onto the employee and pin him from the waist down. The employee was hospitalized with three pelvic fractures, a torn left anterior cruciate ligament (ACL), injury to a knee cap, and pain in the lower back/spine.

An employee was debugging/troubleshooting the teach sensor on a load-handling device (LHD) inside of a cell. The LHD unexpectedly moved to the home location and struck the employee on their head. The employee sustained a head injury, an aspiration-induced lung injury, and fractures to his lower back and right ankle.

The injured employee was holding a pipe while another employee was un-soldering a line. The line split apart and sprayed residual oil on the employee who was holding the pipe. The injured employee sustained second-degree burns to their left hand and arm.

An employee was using a miter saw to cut a piece of wood when the board jumped out from the saw, resulting in a partial amputation to his left thumb.

An employee was working to deliver mail to an apartment building. She was waiting for a customer to move, to obtain clearance to the mailboxes. The door swung inward and closed on her right little finger. The top half of her finger was surgically amputated.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

On October 30, 2025, an employee was working to adjust a stackable metal shipping container. As the container dropped into place, it caught the employee's hands in an area between the upper and lower cross-members. The employee suffered a laceration to the left ring finger that required stitches, bruising to the right ring finger, and fractures to the right middle finger that necessitated medical amputation of the fingertip.

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.