Caught in running equipment or machinery during regular operation · Bruises, contusions
At a glance
Federal OSHA recorded a severe workplace injury
at Drew Foam Companies Inc., 1093 Hwy 278 East, MONTICELLO, ARKANSAS 71655
on — Bruises, contusions, affecting the hand(s) and wrist(s).
Final narrative
An employee was operating a feeder that laminates Styrofoam panels to produce garage door insulation. She was feeding the Styrofoam panels and sheets of film into the feeder when her glove was caught and her right hand was pulled into the machine. She suffered contusions and swelling of the hand and wrist.
HospitalizedHand(s) and wrist(s)Special process machinery, n.e.c.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 326140)
An employee was performing a maintenance task on a shape mold machine. The equipment had a clog preventing it from pumping material into the next stage. The employee's left hand was inside the hopper's butterfly valve when it unexpectedly turned. The employee's index and middle fingertips were partially amputated.
An employee was stacking used cardboard onto a pallet in the shipping and receiving area when he tripped over the scale by the loading dock door. The employee fell to the concrete floor and was hospitalized with a fractured left hip that required surgery.
On May 14, 2025, an employee was manually adjusting a plastic sheet entering the thermoforming oven when their right hand was pulled into the pin chain and idler wheel. The employee sustained the amputation of their middle finger.
At 6:30 p.m. on April 23, 2025, an employee was using a CNC panel saw when his fingers were pinned in by the pressure beam used to hold the board he was cutting. The sawblade, coming from beneath, amputated about 1/4 inch of his right little fingertip.
An employee was diagnosing an issue with a bagger that had jammed. The employee was cleaning out a piece of supporting equipment (a scrap barrel) when the blower motor contacted his right middle fingertip and fingernail, resulting in an amputation. The blower motor was not guarded at the time.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.