ContiTech USA, Inc.

An employee was walking around the wind-up drum of a braiding machine and tripped on the wind-up ramp, causing her to fall on her right hip. She was hospitalized for a hip fracture that required surgery.

An employee was undoing a kink in the mandrel press that she was operating. As the employee was pulling on the mandrel, it let loose and she fell to the concrete floor, fracturing her hip.

An employee was using a manual hoist to lift a roll of fabric when their right index fingertip was caught between the chain and the hook, or between the hook and the roll. The fingertip was amputated without bone loss, at the joint closest to the fingernail.

A boom lift ran over an employee's right foot, causing a fracture of the first metatarsal and a laceration of the foot.

An employee was working near a cure pot when its lid caught the employee's finger, causing an avulsion to the fingertip.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was preparing to cut rubber stock on a pneumatic cutting machine when their middle and ring fingertips were amputated by the cutting blade.

At about 12:25 a.m. on September 3, 2025, an employee was troubleshooting a malfunction involving a slitter whose arbor was not rotating as expected. The employee was observing the slitter's operations when the arbor completed its cycle and the employee's right index finger was drawn into the slitter's 4-inch, non-rotating cutting blade. The fingertip was amputated.

An employee was operating a rolling rope machine. Tooling fell out of the machine and landed on the employee's foot, breaking bones. The machine was not guarded at the time.

An employee was operating a machine when hot air and water was released. The employee sustained burns to the neck, back, buttocks and leg on the right side.

An employee was operating a slitter machine when the roller bar amputated the tips of their right middle, ring and little fingers.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.