Fall on same level due to tripping, unspecified · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Sunflower Electric Power Corporation, Setab 345/115 KV substation, SCOTT CITY, KANSAS 67871
on — Soreness, pain, hurt-nonspecified injury, affecting the back, including spine, spinal cord, unspecified.
Final narrative
An employee tripped and fell while moving equipment, suffering a back injury.
HospitalizedBack, including spine, spinal cord, unspecifiedFloor, unspecified
More severe injuries at Sunflower Electric Power Corporation
An employee was drilling a 15-16-inch hole in a flat steel bracket. The bracket was in a vise, but was not clamped on the table when it started to spin while the employee's hand was resting on it. The employee's finger was caught between the base and bracket, resulting in a partial amputation of the left ring finger at the first knuckle.
While working on nearby equipment, an employee drew an arc of approximately 12 inches from an unpowered electrical line. The power in the line was induced into the circuit from a nearby power source. The employee suffered an electrical shock/burns to the pointer finger and thumb.
An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.
An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.
An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.
More severe injuries in this industry (NAICS 221118)
An employee was operating a dump truck when the trailer door swung and pinched the employee's right middle fingertip underneath the nailbed, resulting in an amputation.
An employee was attaching a turnbuckle to an auger. The turnbuckle slipped and the employee's left thumb was pinched between the turnbuckle and the auger resulting in a partial amputation of left thumb.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.