Direct exposure to electricity, greater than 220 volts · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at D&D Power, LLC, 179 Moores Hill Road, NEW WINDSOR, NEW YORK 12553
on — Electrical burns, unspecified, affecting the head and neck.
Final narrative
An employee was getting ready to bypass a transformer to install a new line pole when the employee clipped the bypass lead onto the center power line and created a short circuit. An arc flash occurred, causing burns to the employee's face and neck.
HospitalizedHead and neckPower lines, transformers, convertors
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
Employees were conducting a snubbing operation. While making up the tubing swivel onto the joint in the mouse hole, employee 2 proceeded to pull power tongs off the pipe. At the same time, the injured employee went to re-adjust the tong heads. The make/brake handle was pulled and the injured employee's right hand got caught in the tongs. The injured employee's index, middle, and ring fingers were amputated and he required surgery.
On 9/26/2025, an employee was using a pair of scissors to cut a zip-tie that was securing a box of files. The scissors slipped and lacerated the employee s left wrist. The employee was hospitalized.
An employee was troubleshooting and rodding out a piece of process piping equipment when their left index finger was caught between the tool handle and threaded flange. The employee's fingertip was partially amputated.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.