Norriseal-Wellmark

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

The belt on an air compressor had just been put back into place after turning upside down. An employee was working to take a picture of the identifying numbers on the belt so that a replacement could be ordered when the compressor rolled, causing the pulley to spin. The employee's right index finger was caught between the pulley and the belt, and the fingertip was amputated at the first knuckle.

An employee was receiving a 660-pound beverage vending machine for repair. While the machine was being moved from the back of the van to the lift gate, the caster wheel was caught between the van and the lift, causing the machine to fall onto the employee and pin him from the waist down. The employee was hospitalized with three pelvic fractures, a torn left anterior cruciate ligament (ACL), injury to a knee cap, and pain in the lower back/spine.

An employee was debugging/troubleshooting the teach sensor on a load-handling device (LHD) inside of a cell. The LHD unexpectedly moved to the home location and struck the employee on their head. The employee sustained a head injury, an aspiration-induced lung injury, and fractures to his lower back and right ankle.

The injured employee was holding a pipe while another employee was un-soldering a line. The line split apart and sprayed residual oil on the employee who was holding the pipe. The injured employee sustained second-degree burns to their left hand and arm.

An employee was using a miter saw to cut a piece of wood when the board jumped out from the saw, resulting in a partial amputation to his left thumb.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.