Steve's Plumbing, Inc.

On November 9, 2023, an employee was removing plywood from the west face of a basement level buck hoist to prepare to dismantle one of the cabs. When the employee pulled on the plywood, it fell and pulled a rope that partially amputated the employee's thumb.

An employee was holding a rigging line and assisting in the removal of an old light pole from its base. When the load was lifted by a forklift, it shifted. The tag line lifted the employee off the ground and propelled him through the air. The employee landed on the ground and sustained back fractures.

An employee was performing maintenance on a bucket truck when his right hand became caught in some rope, causing amputations to three fingers down to the first knuckle.

An employee was conducting a fall rescue demonstration. A 165-pound demonstration dummy was released from a height, putting tension on the lanyard. The employee's left hand, little finger, and thumb were caught in the wire rope lanyard, resulting in a medical amputation of the left little finger as well as lacerations to the left thumb.

An employee was using a crank and cable to lower a light tower due to windy conditions. The light shaft became hung up and released the tension in the cable, which wrapped around the employee's left hand, resulting in amputations of three fingers.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.

An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.

While working at a customer's residence, an employee was cutting tape with a box cutter to wrap insulation for a piece of pipe. The box cutter struck a hardened object within the wall causing it to bounce back and puncture the employee's right eye. The employee was hospitalized.

An employee was assembling a baker type scaffold. He was beginning to transverse down the scaffold, approximately six feet off the ground, when the scaffold tipped over and he fell. The employee was hospitalized with a fractured femur.

An employee was trimming out sprinklers on the exterior of a building when he fell off an extension ladder. He landed on the ground and sustained fractures to his nose and arm.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.