CenturyLink

An employee was working at mid-span between two telephone poles (that is, on a ladder set between the poles and designed to fit between them). The ladder slipped and the employee fell to the ground about 12 feet below, landing on his feet and shattering both heels.

An employee was walking in an office, lost balance, and fell resulting in a hip injury.

An employee had been pulling cable and was hospitalized for heat related illness.

An employee had been using a bucket truck to repair a telecommunications cable at a customer's residence. The employee completed the job and got down into the truck bed from the bucket itself, and was then stepping off the platform at the rear of the truck when he missed a step, lost balance and fell from the back of the truck to the ground approximately 4-5 ft below. The employee landed on his tool belt and the right side of his lower back. He was hospitalized with four fractured vertebrae in the lower back.

An employee was walking to his truck at a remote site when his knee gave out due to a torn or dislocated tendon. He was hospitalized for surgery.

An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.

An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.

An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.

An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.

An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.

On June 16, 2025, at 4:30 p.m., an employee was ascending an 8-foot A-frame ladder to look inside an attic opening of a customer's garage. The employee was three rungs from the top when he fell 5 feet to the ground, resulting in a displaced fracture of his femur in the back of his knee. The employee was hospitalized and required surgery.

An employee was about to install a cable at a residential site. While setting up a ladder, he stepped back on an uneven street surface and hyperextended his knee. He dislocated his knee and tore his patellar tendon.

An employee was descending a ladder when it shifted, slid, and twisted. The employee fell about 12 feet to the ground and broke his left hip. He was hospitalized and required surgery.

An employee lost his balance when the extension ladder he was on shifted and he fell approximately 15 feet to the ground, resulting in fractures to his elbow and hip.

An employee fell while lifting a box and suffered a wrist injury.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.