Marsh Bellofram Corporation

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

On November 9, 2023, an employee lifted a 70-pound package of paper bags, put it in a cart, and then pushed the cart to the front of the store by the cash registers. The employee sustained a collapsed lung.

An employee was providing medical treatment to injured persons involved in a motor vehicle accident. The employee was walking up and down a low-grade embankment carrying injured persons on transport equipment such as backboards. The employee sustained chest pain, and a possible cardiac related event with an elevated heart rate and elevated blood pressure.

An employee was moving merchandise in boxes, rolling containers, and totes, from a truck to store shelves when they sustained back and neck injuries.

An employee was using a shovel to dig a hole for a pipe when he suffered a broken vertebra. He was hospitalized.

On June 16, 2023, an employee was elevated in a scissor lift and was removing a pipe from a structure when they began experiencing back pain. The employee sustained a ruptured abdominal aneurysm from lifting/carrying/pulling pipe.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was performing stamping operations using a 160-ton press machine. They began to clean the machine when the press came down on their hand, resulting in multiple finger amputations.

An employee was feeding a ring into a horizontal winder when the ring got caught. As the employee was getting it to continue feeding into the machine, her right middle finger was caught in a pinch point on the machine's wheel. The fingertip was partially amputated.

An employee was operating a tape cutting machine, which automatically cuts 2-inch cloth material into predetermined lengths. The material became jammed in the blade, which froze in the partway down position. The employee began working to unjam the material. The machine activated, causing the blade to become free. The blade came down and amputated the employee's left index fingertip above the first knuckle and the tip of their left thumb.

An employee was adjusting a ring on a bar bending machine when their glove became caught in a pinch point on the machine. The machine was activated and the employee sustained fractures to the four fingers on their right hand and amputations to the index and little fingers.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.