Reitnouer

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was assisting with rigging a magnet to an overhead crane in order to lift a sheet of steel. The employee's right thumb was between the crane's hook and the chain passing through the hook, and when the crane was raised, the distal end of their thumb was crushed. Part of the employee's right thumb was medically amputated.

Two employees were working together to insert a pin into a hydraulic cylinder. One employee was holding the cylinder in place to align it with the pinhole, while the injured employee was inserting the pin. The injured employee was aligning the pin and moved to determine whether the hole alignment was too high or low. At that moment, the crowbar being used to assist with alignment slipped and his left index fingertip was pinched between the cylinder and the housing, resulting in an amputation just below the fingernail.

An employee was hoisting an axle in the buggy department when one side of the sling came loose, causing the axle to tip. The sling hook raised up from the weight transfer, causing the employee's left little finger to be caught by the rigidness of the hook. The fingertip was amputated.

An employee was using a circular saw to cut the cap off an aluminum bulkhead of a trailer that was being manufactured. The saw kicked, lacerating his hand and resulting in the amputation of his left middle and ring fingertips.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.