Fall on same level due to tripping over an object · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Gilster-Mary Lee Corporation, 1037 State St, CHESTER, ILLINOIS 62233
on — Fractures, affecting the thigh(s).
Final narrative
An employee was stacking a skid and tripped over a roll of stretch wrap that was on the walking surface. The employee sustained a fractured femur.
HospitalizedThigh(s)Floor, n.e.c.
More severe injuries at Gilster-Mary Lee Corporation
An employee was driving a forklift in reverse to move materials when the forklift ran into a skid that was up on a rack. A finger on the employee's right hand was crushed between the forklift support bar and the skid, resulting in an amputation to the finger.
An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.
An employee was cleaning a single-facer machine. The employee's fingertips were crushed between rollers in the machine. The employee was hospitalized, and the fingertips were medically amputated.
An employee was working on a pasta-making machine. The employee had removed and cleaned the screw. He was trying to line the screw up to slide it back into the barrel. When the screw was tapped with a mallet, his finger was caught between the screw and the wall of the barrel, causing an amputation to the finger.
On 6/18/2022, an employee had been driving a tow motor and putting finished products on the pallet wrapper machine when plastic wrap got jammed. The employee got off the tow motor and climbed onto the pallet wrapper to clear the jam. When he grabbed the wrap, his hand was pulled between the turntable and roller bed of the pallet wrapper. His hand was pinned/crushed causing broken bones in the right thumb and index finger. The machine was running at the time.
An employee arrived at work and was walking into the store through the parking lot. The employee tripped over a curb and fell to the ground, sustaining a femur fracture.
A team was disassembling a dough pump s auger to allow the wastewater to drain from an allergen changeover. The auger became stuck due to suction caused by residual wet dough. A paddle was being used to pry the auger loose when the suction force suddenly released, causing the auger to retract unexpectedly. A finger on the employee's left hand was caught between the auger and the housing, leading to an amputation to that finger.
On February 4, 2025, at approximately 6:20 PM, an employee was cleaning the dough inside a divider when they sustained an amputation to their right index fingertip.
An employee was troubleshooting a mixer on the biscuit line when their hand became caught under the machine belt, resulting in fractures and an amputation of their middle fingertip. The machine was not locked out/tagged out at the time.
An employee was operating the bake sealer (used to seal the product) on the line and there a change over in the process. The employee was moving the bake sealer when he slipped and his hands were caught between the moving belts of it, resulting in a partial amputation of the left little finger.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.