Injured by handheld object or equipment, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Harris Davis Rebar, LLC, Village on the River, SIOUX FALLS, SOUTH DAKOTA 57104
on — Fractures, affecting the forearm(s).
Final narrative
An employee was de-stressing cabling on a flat pour due to a failed concrete test. The de-tensioning tool slipped and struck the employee, breaking the employee's left radius and causing a hand laceration.
HospitalizedForearm(s)Handtools-power not determined, unspecified
An employee was tailing logs with a chainsaw. As they set the chainsaw on a log, the chain contacted the employee's left index finger, fracturing it. The fingertip was surgically amputated.
An employee was using a Johnson bar to pry a piece of concrete with the help of a skid steer. When the bar moved, the employee was struck in the mouth by it, resulting in a tooth avulsion and a mouth injury that required stitches.
An employee was helping another employee pick up a round piece of metal to recoup a skid. The metal slipped and lacerated the employee's right middle finger, resulting in a fingertip amputation.
An employee was attaching a wrench to a drill rig rod. The wrench turned and struck the employee's right hand, resulting in a laceration and fracture to their index finger.
An employee was climbing a ladder while carrying 12-foot metal trims to the roof. As the top end of the metal rose above the parapet wall of the roof, a strong gust of wind spun the metal backward, causing the employee to lose his grip on the metal. The trims lacerated his left wrist, which required hospitalization and surgery.
More severe injuries in this industry (NAICS 238120)
An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.
An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.