Conn-Weld Industries, Inc.

An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.

An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.

An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.

An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.

An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.

An employee was standing at the rear of a machine and the machine's mesh tray fell down onto the rear of the machine, crushing his left hand against the read lift. The employee sustained fractures and a laceration to their left hand and was hospitalized.

The injured employee was assisting with tightening down 3/4" hardware during assembly of a 6'x20' triple deck screen. Another employee was using a 1/2" cordless impact wrench to tighten down the hardware. The injured employee was using a 1-1/8" open-end wrench that slipped when the bolt was being tighten down by the impact wrench. The injured employee's right ring fingertip was caught between the open-end wrench and the side sheet of the triple deck screen. The tuft of the distal phalanx was amputated.

An employee was welding baffle plates onto a 55-gallon hydraulic tank. A flash occurred as they began to tack weld a part. The employee suffered burns to most of their face and second-degree burns on each arm, resulting in hospitalization.

An employee was cutting a piece of rubber with a utility knife. The knife slipped and partially amputated the employee's right index fingertip.

On July 22, 2024, an employee was using a pressure washer to fill a mop bucket with water. The washer's hose split and soapy water was injected into the employee's right palm and index finger. The puncture wound had to be surgically cleaned.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.