Caught in running equipment or machinery, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Quaker Oats, 7700 W. 71st. Street, BRIDGEVIEW, ILLINOIS 60455
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was checking the belt on the infeed conveyor of a palletizer. The belt began to move and pulled the employee's right middle finger into the running palletizer resulting in a fingertip amputation.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
Two forklift drivers were stopped next to each other and were talking. The injured employee leaned out of their forklift as the other forklift was leaving and they became pinned between the two forklifts. The injured employee was hospitalized with a fractured rib and a lacerated lung.
At about 3:30 p.m. on May 8, 2025, an employee slipped and fell backward while walking around equipment. He landed on the ground, near a water trench into which a steam line and a condensation return line were piped. Hot water from the trench burned his back between the shoulder blades.
An employee was troubleshooting a motor when their right little finger became pinched between the belt and pulley, resulting in amputation of the fingertip.
An employee was driving a forklift to a shipping dock. While he was rounding a corner, a stack of totes fell, and the top of one of the totes struck the outside of his left calf. He was hospitalized.
A crew was preparing a 20-foot section of 12-inch high-density polyethylene (HDPE) pipe to be swung into a welder using an excavator, where it would be welded onto a longer run of pipe. One employee was facing the longer pipe in the welder while the 20-foot section was being rigged. The 20-foot section moved and struck the employee's left knee. The employee's left leg was broken below the knee.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.