Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Kaylor Grain Co., Inc., 28351 421st Avenue, OLIVET, SOUTH DAKOTA 57052
on — Amputations, affecting the fingertip(s).
Final narrative
An employee noticed a blockage in an auger system while delivering grain to an offsite customer. The auger caught her hand against the side of the trough, causing the amputation of the tip of her little finger.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 311119)
An employee was working on removing the gearbox from the drive shaft of the motor assembly of a feather drier. He was using a hydraulic tool to pull the pieces apart when a bolt dislodged from the eye of the gearbox and the corner of the gearbox broke off. The employee was struck in the nose (sinus cavity), resulting in hospitalization and surgery.
An employee was on a forklift checking the sprinkler system drain. The employee fell 8 feet from the forklift to the floor. The employee suffered a broken collar bone and was hospitalized.
An employee was working as a dumper on a packaging line. A passing forklift turned and pinned the employee against a guardrail. The employee suffered fractures to their ribs and a leg requiring hospitalization.
An employee was cleaning an upper mezzanine. When he leaned against the mezzanine gate, he fell through the gate opening and landed 11 feet below. The employee sustained fractured orbital bones.
An employee was assigned to clean a feed mill in the basement. He then rode a tool and material basket to return from the basement to the ground level. He fell out of the basket and landed about 5 feet below. The employee sustained fractures to his arm, lower back, and foot.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.