LM Wind Power Blades (ND), Inc.

An employee was repairing the inside of a turbine blade when he fell onto a sharp edge protruding from the work surface. The employee sustained a laceration to his right arm requiring hospitalization.

An employee was cleaning out glass fibers in a small channel that houses a cutting blade on a cutting machine and suffered a fingertip amputation.

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

Two employees were hospitalized for electrical shock and burns after contacting energized electrical components of a turbine system.

Four employees were traveling in a utility task vehicle (UTV) on the east lot of the site. While turning, the UTV flipped over onto the driver's side. The driver's left wrist and hand were crushed by the frame of the UTV resulting in a fractured and dislocated wrist, as well as hand injuries. The driver was hospitalized and required surgery.

On August 15th, 2025, an employee was aligning/connecting a coupler to the generator of a wind turbine. The coupler was secured in place by a strap that was connected to the turbine's chain hoist and a bolt. While lining up the remaining holes, the coupler rotated while the employee's right index finger was in one of the bolt holes, causing a partial amputation through the phalanx.

Employees were preparing to unload a wind turbine gearbox from a flatbed trailer. An employee went to reposition himself on the flatbed trailer and grabbed onto a wooden piece of the shipping cribbing for support. The piece of wood began to come loose, causing the employee to lose his balance. The employee jumped to the ground about 4 feet below and landed on his feet. His left ankle rolled and the employee was hospitalized with a fractured ankle that required surgery.

An employee was working to move a paper roller carriage, which is a 3 by 3-foot paper roll weighing approximately 500 pounds. The employee's hands were positioned in the area where the spool meets the cradle. As the employee moved the carriage across a floor track, the paper roll was dislodged and caught the employee's finger, severing it. The employee's right middle fingertip was partially amputated.

An employee fell from a dock to ground level (less than 4 feet) and broke their tibia/knee.

An employee was on the ground working to close a trailer door. The door was caught by the wind and blew the employee backward. He landed on his back and sustained four fractured ribs, requiring hospitalization.

An employee was walking on top of boiler to close a valve. The employee fell off the boiler and landed on the floor, sustaining fractured ribs. The employee was hospitalized.

An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.

An employee's left bicep was lacerated by high-pressure water during water blasting operations. The employee was hospitalized.