Cape Seafoods, LLC

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

On July 7, 2025, an employee was cleaning food from under a conveyor belt. He was retrieving a piece of food when his left middle finger contacted the chain and pulley. The fingertip was amputated. The machine was guarded at the time of the incident.

On December 16, 2024, at approximately 3:07 p.m., an employee was feeding frozen fish blocks via a conveyor belt into a floor mounted electrically powered grinder. The grinder became jammed with the fish material. The worker deenergized the machine and used a rolling ladder to climb approximately 4 feet in the air to unjam it. As the fish block became dislodged, the momentum of the action caused the fish block to slam down on her right thumb and the machine, causing a partial amputation of the thumb tip.

An employee opened a fillet machine to remove a fish that had gotten stuck when their left hand made contact with the blade, resulting in cut ligaments between the thumb and index finger.

An employee was cleaning a fryer when cleaning chemicals contacted their left leg, resulting in chemical burns.

An employee was moving a loading ramp to the dock when the ramp became stuck. While dislodging it, the ramp fell on their left hand. The employee sustained a partial amputation to their left middle finger.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.