Jay-Bee Oil & Gas, Inc.

An 18-inch pipe rolled off the forks of a loader when the clamps were lowered. Two employees' legs were pinned between the pipes.

On November 27, 2023, an employee was emptying a 2-inch product line that transports sodium hydroxide liquid from a rail car to a 275-gallon tote tank. The nozzle came out of the tote and sprayed sodium hydroxide onto the employee's face. The employee was hospitalized with chemical burns to their face, mouth, and neck.

An employee was working with sulfuric acid as part of the production process. While transferring the chemical from a large container to a smaller container, it splashed on his body and hand, resulting in a chemical burn.

An employee knelt in wet concrete while performing work as a concrete finisher and sustained a chemical burn to the right shin. The employee was hospitalized and required surgery.

An employee was using a 5-gallon bucket to unload acid product from a tank. Residual product leaked into the containment area, causing the employee to sustain first- and second-degree burns to the chest, as well as third-degree burns to the arms.

An employee was transferring an alkaline cleaning chemical from a bulk container into 1-gallon containers. The employee lifted a gallon container by its label tag. The tag broke causing the container to fall approximately 14-18 inches. The container struck the ground and the contents splashed onto the employee causing chemical burns to their eyes.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.

An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.

An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.

An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.