Jay-Bee Oil & Gas, Inc.

A well tender was putting methanol in a dump-line when the nipple broke off the line. Methanol sprayed into the employee's face and eyes; the employee was hospitalized.

An employee was collecting trash when they were struck by a rolling utility trailer. The employee sustained a right ankle fracture.

An employee was unrigging steel when an 8-inch by 50-foot, 4,875-pound piece of steel rolled onto their left leg, resulting in a fracture.

An employee was connecting a dolly to a trailer. The equipment rolled away, causing the employee's left index finger to be crushed between the trailer and the dolly. The employee sustained amputation of the fingertip.

On October 17, 2023, at 9:55 p.m., an employee was working on a ramp while moving merchandise from a cargo loader to a dolly. The employee was putting the locks on the dolly and transferring a unit load device containing packages when she realized the lock was in the down position. As she attempted to fix the lock, the unit load device started moving toward the dolly, and the employee became wedged between the dolly and the device. The employee suffered an injury to her lower left leg.

Two employees were shaking out steel beams and standing them vertically. One beam was hit, causing the other beams to fall. A beam then rolled over an employee's left shin and fractured it. The employee was hospitalized and required surgery.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.

An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.

An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.

An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.