Direct exposure to electricity, greater than 220 volts · Third or fourth degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at BUSCH AGRICULTURAL RESOURCES, INC, 3723 COUNTY RD 905, JONESBORO, ARKANSAS 72401
on — Third or fourth degree electrical burns, affecting the wrist(s) and arm(s), n.e.c..
Final narrative
An employee was on an aerial man lift inspecting a roof when the employee contacted a powerline, suffering second/third degree burns on the right arm from the bicep to the wrist.
HospitalizedWrist(s) and arm(s), n.e.c.Power lines, transformers, convertors
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
On November 21, 2024, at approximately 7:55 a.m., an employee was getting onto a manlift on the fourth floor while holding two scoop shovels. As he stepped onto the lift, the shovels got caught on the floor, causing him to slip off the step and grab the floor. The employee fell to the concrete third floor, resulting in 4 fractured right ribs and 3 fractured left ribs. He also dislocated his right shoulder.
An employee was riding a manlift up from the ground floor when they fell several feet from the manlift to the floor. The employee sustained a fractured left femur.
An employee was changing out a flex hose at a soaking tank when part of a T-valve burst on the soaking tank, resulting in burns to their torso from the hot water.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.