Caught in running equipment or machinery, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at HEAT TRANSFER SYSTEMS OF GEORGIA, LLC, 1 Chemical Plant, RICEBORO, GEORGIA 31323
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
While working at a cooling tower, an employee was adjusting/leveling a motor and fan. The fan was turned on, which activated the belt and pulley. The employee's left hand contacted the fan's belt and pulley, resulting in a partial amputation (first joint) of the fifth digit.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
An employee was laying underneath a cooler block while jacking up the tie bar to secure it to horses when the cooler block fell off the horses and onto the employee, resulting in several fractures to the pelvis, clavicle, wrist and tailbone.
An employee was climbing a ladder on a water cooling tower when they fell approximately 15 to 20 feet to the ground, resulting in a fractured left elbow.
An employee was preparing to sand a metal shaft that was loaded into a lathe when his left arm became entangled in the machine. The employee sustained several broken bones.
An employee was removing the banding from a load of mechanical supports, when one fell forward onto his left leg. The employee sustained a laceration to the lower leg and was hospitalized.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.