Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Willier Electric Motor Repair co., Inc, 1 Linden Ave, GIBBSBORO, NEW JERSEY 08026
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was running a lathe to finish a repaired shaft. The employee was using sandpaper to finish the shaft when the employee's shirt was caught in a rotating piece, pulling the employee's arm and hand into the rotating piece. The employee suffered a left ear laceration as well as a broken left arm, wrist, and hand. The employee's left little finger had to be surgically amputated.
An employee was troubleshooting a variable frequency drive (VFD). There was an electrical discharge. The employee experienced an electrical shock of approximately 480 volts and sustained second- and third-degree burns on their right hand, wrist, forearm, and elbow.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 335312)
An employee was cleaning a machine and bleeding its lines. After the gauge read 0, the employee removed the metal lid covering a filter. The lid popped off and struck the employee in the face, causing a broken nose, a broken jaw, and lacerations.
An employee was troubleshooting a variable frequency drive (VFD). There was an electrical discharge. The employee experienced an electrical shock of approximately 480 volts and sustained second- and third-degree burns on their right hand, wrist, forearm, and elbow.
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.