Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Saf-T-Cart, 1322 Industrial Park Drive, CLARKSDALE, MISSISSIPPI 38614
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was cutting a piece of metal that got caught on the blade. The saw blade amputated the employee's right ring and little fingers.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
On October 18, 2022, at approximately 7:30 AM, an employee was removing the mounting bolts from a juice extractor motor. Upon removing the last bolt, the motor released, catching their left thumb between the motor and the lifting jig. The employee sustained a broken thumb and laceration, resulting in hospitalization.
An employee was operating a brake press to bend metal. His right-hand fingers were caught in its point of operation, and he suffered amputations to four of them.
An employee had a long screw auger set on pipe stands approximately 4 feet from the ground. One of the pipe stands tipped as he was adjusting the auger, causing the auger to fall onto his foot and fracture it.
An employee was moving a punch press tool from its storage location onto an electric die cart when the press tool fell on the employee's finger, resulting in an amputation of the left ring fingertip above the top knuckle.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.